- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- VCEM Migration - A Few Questions
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-20-2011 06:50 PM
12-20-2011 06:50 PM
VCEM Migration - A Few Questions
Hello,
I have a new VCEM install that I would like to migrate our current VC's into but I have a few questions. I added a few of the VC's into VCEM and went to add them into a new VC Domain Group. I am confused as to what will happen with the Range Type Selection. The VC's are currently setup to use the HP Pre-defined MAC's and WWN's and I understand that you must use the VCEM scheme but does that mean VCEM will re-address the configuration of the VC's?
Thank you!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-21-2011 07:17 AM - edited 12-21-2011 07:18 AM
12-21-2011 07:17 AM - edited 12-21-2011 07:18 AM
Re: VCEM Migration - A Few Questions
I have done this and it brought in the existing HP Pre-Defined MAC and WWN addresses. If I add or delete and re-add ports it then uses the VCEM addresses. If I delete a profile - the addresses all change to VCEM, I've done this and had to the new WWN's zoned.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2011 10:29 PM
12-28-2011 10:29 PM
Re: VCEM Migration - A Few Questions
You can find me from Twitter @JKytsi