HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

VMware and Virtual Conenct Flex10... VLAN 1

 
chuckk281
Trusted Contributor

VMware and Virtual Conenct Flex10... VLAN 1

Mohamed had a customer question:

 

***********************

 

Dear experts

            I have an issue when I configured the Virtual Connect Flex-10 with the VLAN ID 1 , “ default VLAN ... I can communicate with all other vlan expect this VLAN ..."

 

Any suggestion ...

 

***********************

 

Lionel replied:

 

********************

 

On Cisco, the default native VLAN is by default 1 and is always untagged so make sure the VLAN1 of your shared Uplink Set is Native enabled.

 

***************

 

Mohamed was good to go:

 

********************

 

Thanks a lot

The was resolved after enabled native vlan 1 in the SUS ...

 

****************

 

Any other comments or suggestions?