HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect 1/10 GbE and VC FlexFabric in same enclosure

 
chuckk281
Trusted Contributor

Virtual Connect 1/10 GbE and VC FlexFabric in same enclosure

Robert had a VC configuration support question:

 

*****************

 

Is this configuration supported?

 

webpic208.png

 

***************

 

Fred replied:

 

*****************

 

There are a few problems with what’s shown. First, there’s a mix of VC firmware in the domain. The 1/10-Enet modules are at 3.60 which was the most recent release of VC firmware supporting them. The FlexFabric modules have been upgraded to VC 3.75. The version of VC firmware must be consistent across all modules in the domain. The FC modules are running firmware that was included in VC 3.51, 3.60 and 3.70.

 

To correct this, downgrade your FlexFabric modules to VC 3.60 or remove the 1/10 modules from the enclosure.

 

***************

 

Questions or comments?