HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect Active/Active Uplinks question

 
chuckk281
Trusted Contributor

Virtual Connect Active/Active Uplinks question

Talha had a customer question:

 

***************

 

I have a customer with 2 x HP VC Flex-10 Enet Modules.

 

Usually at customers when a SUS has 2 x Uplinks 1 from each IC Module, the second link is in Standby Mode. However, In this case both are Active, why is this so.

 

Is this because there no Stacking Links between IC Bay 1 and IC Bay 2 (i.e. SFP’s in X7 and X8).

 

**************

 

Reply from Robert:

 

*************

 

That would be the cause, for sure.  The loop-avoidance mechanism is not seeing any loop, so no uplinks are in standby state.

 

This is not a good position to be in, in my view.  Why are there no stacking links between modules???

 

*************

 

Input from Mark:

 

************

 

I agree, fix the stacking link issue.

 

***************

 

Comments?