Virtual Connect FC issue

[WilliamSmith11]

With the four module in place same result

[Torsten.]

can you connect to the modules in bay 1 and 2 now?

there is no management link to the FC modules.

[WilliamSmith11]

Sure I can connect to module 1 or module 2 , but can not reach module 3 or 4 cause there no communication,

I have try to set iP address to the module 3 and 4 manually but it is not taken by the modules.

[Torsten.]

you cannot connect to these modules, the ethernet modules will control them.

[aisaddi]

I have also the same problem on a C7000. One SAN Module on Interconnect Bay 3 did not get a management IP.  So no communiction between Enclosue and Module and therefore we get no connection to SAN switch outside. I reseted, un-/replug and changed the SAN module. Nothing helps.

Did anyone get meanwhile a solution for that problem?

Regards

Karlheinz

[Torsten.]

I'm not sure at the moment if VC FC modules get an IP or not.

However, you cannot access them, that is normal.

All configuration is done via the VC ethernet modules.

[aisaddi]

Hi Torsten,

I know that I cannot access the SAN modules direct. But the IP is needed that the SAN Module can communicate with the Enclosure and Ethernet module. 

The module on Bay 4 get an IP but not the moduel in Bay 3.

I have 22 Enclosures in my responibillity and only one has this strange error.

best regards

Karlheinz

[frenchy94]

Try to switch module in slot (module in slot 3 in slot 4 module in slot 4 in
slot 3) to see if follow module



---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus

[Torsten.]

No need to swap the module bays, you can also try in an empty slot.