HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect Flex Fabric and "adaptive load balancing" (Linux bonding mode 6)

 
admintauli
Occasional Visitor

Virtual Connect Flex Fabric and "adaptive load balancing" (Linux bonding mode 6)

Hi,

 

According to documentation Virtual Connect supports all modes of Linux interface bonding, but I discovered that Linux only supports bondig with interfaces at "tradicional" speeds (100Mb, 1Gb, 10Gb).

 

No problem, I go to the server profile to limit allocated port speeds to 1Gb.

 

Fail! allocation defines a range of speeds from my custom (1Gb) to a VC auto-calculated value that I can't control and Linux recognizes... causing the bonding failure.


¿There are any method to control the range of speeds allocated?


Thank you in advance