HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
BladeSystem Virtual Connect
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect Flex10 internal X-connect

 
chuckk281
chuckk281
Trusted Contributor

‎03-17-2011 08:50 AM

‎03-17-2011 08:50 AM

Virtual Connect Flex10 internal X-connect

John had a Virtual Connect x-connect internal link question:

 

******************

 

Do the Virtual Connect Flex-10 interconnects really need the stacking links X7 and or X8 to synchronize or checkpoint? I was under the assumption that they did this through the internal network that is setup when you give ip’s to the OA, ILO and interconnects.

 

*******************

 

Andeas replied:

 

**********************

 

There is no internal communication, if both ports are used for uplinks.

 

******************

 

Comments? Questions? Good to know if you want to have greater netowrk physical separation. Bad if you want redundacy and don't use any of the uplink ports for stacking links.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.