HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect FlexFabric modules without X-links

 
chuckk281
Trusted Contributor

Virtual Connect FlexFabric modules without X-links

Vasyl had a customer situtation:

 

*****************

 

Hi community,

 

Customer needs to have four 1Gb RJ-45 uplinks per FlexFabric module (total of two modules), so cross-link ports between modules will not be used. Is it supported config?

 

*************

 

Input from Robert:

 

**************

 

This is not supported.  You may however use one or two external 10G connections using X1-X4 ports between the adjacent modules to achieve the required stacking links.

 

**************

 

Other comments or suggestions?