- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect FlexFabric - uplink "Connected to"...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2011 07:45 AM
10-28-2011 07:45 AM
Virtual Connect FlexFabric - uplink "Connected to" info question
Kelly was getting some wierd info about uplink status:
******************
Was wondering if anyone has see the following, some of my uplinks show “connected to” data, others do not. Any ideas what could cause that? This is a relatively new install and we are still working out some issues.
Theoretically, all of these ports are configured the same, just different vlans. The network admin says all looks the same on his side.
************************
Info from Vincent:
******************
Most likely Bay 1 port X5 is connected to a switch where LLDP is enabled, and the other ports are going somewhere else where LLDP is not enabled. You can further troubleshoot by going to the Hardware Overview section, Interconnect Bays, Bay 1, and click on the Detailed statistics/information link for each of the uplinks, scroll down to the Remote Device Information section, that’s the decoding of the LLDP PDUs that VC is receiving on that port. Compare what you get on X5 with what you get on the other ports.
*****************
Any other comments or suggestions for Kelly?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-30-2011 02:55 PM
11-30-2011 02:55 PM
Re: Virtual Connect FlexFabric - uplink "Connected to" info question
What is the VC fw? VC 3.17: The "Connected To" column is still there but does not always populate. With VC 3.30 this feature will return.