- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect FlexFabric with FCoE and iSCSI
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2010 12:52 PM
12-02-2010 12:52 PM
Virtual Connect FlexFabric with FCoE and iSCSI
Timo had a VC FlexFabric question:
*********************
Hi,
Is it supported to run single pair of FlexFabric modules with profiles having FCoE and profiles having iSCSI ? Or do I need dedicated chassis for FCoE and dedicated chassis for iSCSI ?
**************************
Sam replied with the info:
************************
No problem, in fact I’ve demonstrated this in a demo rig used for shows.
You can mix FCoE and iSCSI networks in the same VC Domain. The only restriction is both FlexHBA ports of the same adapter (i.e. – LOM or MEZZ), must be either configured for FCoE or iSCSI. See possible combinations in chart below.
Also, as a general rule, if the VCM GUI allows the configuration to save without degradation, it’s supported.
*************************
Are you using the new VC FlexFabric module? Comments or questions?