HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect Manager UI is broken

 
unixnerd23
Occasional Visitor

Virtual Connect Manager UI is broken

Hello All,

My business is using an HP C7000 enclosure. We had an ethernet mezzanine module fail last week which caused our entire production network to go down. Through the process of attempting to resolve this issue I ran into some issues with Virtual Connect Manager. After replacing the failed mezzanine module I logged into the VCM. The first problem that I ran into was the "Loading Libraries 4%" issue. Which I resolved with the following post:

https://community.hpe.com/t5/HPE-BladeSystem-Virtual-Connect/loading-libraries-on-virtual-connect-manager/td-p/6744910

However after resolving the 'loading libraries' issue the VCM is broken. When I click on various configuration settings within VCM the WebUI returns blank white space within the framework of the web interface.. There is also no drop down menu along the left hand side of the UI.

I have been tasked with getting this C7000 enclosure working again until we can allocate budget to our Co-Location for new hardware. Has anyone seen this problem before? Or have any recommendations to get VCM's WebUI functioning again?

Outside of the VCM WebUI I do have CLI access to VCM for this enclosure however the CLI is not very intuitive. Ultimately what I need to do is get this new (identical) ethernet mezzanine module functioning again. If I must use the CLI at this point what commands would I run to configure the new mezzanine card? I can review the configuration settings of the enclosure within Onboard Administrator. I just can't make changes within VCM.

Can someone please help me with this situation?

Thanks!

2 REPLIES
Torsten.
Acclaimed Contributor

Re: Virtual Connect Manager UI is broken

Does this apply?

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04677033


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
unixnerd23
Occasional Visitor

Re: Virtual Connect Manager UI is broken

Hello,

Thank you for your response.

I will give this a shot and get back to you.

Thanks!