- Community Home
- >
- Servers and Operating Systems
- >
- BladeSystem
- >
- BladeSystem Virtual Connect
- >
- c7000/virtual connect Net. connect issue - only ge...
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Latin America
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
10-06-2017 01:23 AM - edited 10-06-2017 01:24 AM
10-06-2017 01:23 AM - edited 10-06-2017 01:24 AM
c7000/virtual connect Net. connect issue - only getting ip to one server in my bladecenter
Setup:
1 - HP Bladecenter C7000
9 - bl465 g7 and bl685 g7 blades w/ standard dual emulex 10gb flexnics
1 - HP 1/10gb VC-Enet Module
I am running this enclosure from my home. So I am using a cablemodem/router from my cable company with a small netgear gigbit unmanaged switch in between. I have network cables plugged into the first 2 ports on the Interconnect card.
ive set up virtual connect manager to the best of my knowledge. I am able to get an ip just fine on my first blade that is running windows server 2016. My second blade running a linux live cd w/ correct nic drivers installed just wont pull an IPv4 address. I just show 100% dropped Rx packets uder ifconfig.
Ultimately What I am wanting set up is a fully populated blade center. The first server will house a hard drive and a pxe server and I want to network boot a live cd to ram (diskless) for the other 15 servers.
Any help would be greatly appreciated, I have been fighting with this for several days and I need to get this setup. I am not sure if maybe I need a better switch or router?
Thanks in advance
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP