HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

change the enclosure ID in the Domain Settings (C7000)

 
SOLVED
Go to solution
Highlighted
zsoltesz
Occasional Contributor

change the enclosure ID in the Domain Settings (C7000)

Hi,

Is it possible to change the Enclosure ID in the Virtual Connect? 

We started to monitor our devices, and we have 5 enc0 (because we have 5 C7000 bladesystems.)

Thank you for any advice!

Zoli

enc0.png

2 REPLIES
sidp_123
Visitor
Solution

Re: change the enclosure ID in the Domain Settings (C7000)

Hi Zoli,

No, We cannot change the Encloure ID.

If its only One enclosure with VC domain, it would be Enc0 as the ID.

If you have 2 enclosures part of one VC domain, then you would be having Enclosure IDs as Enc0 and Enc1.

Enc0 would be always Primary enclosure where you would be having Virtual connect domain.

zsoltesz
Occasional Contributor

Re: change the enclosure ID in the Domain Settings (C7000)

I was hoping that there is a tricky way to change the ID. Thank you for your answer.