HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

primary and secondary ports on fail-over mode

 

primary and secondary ports on fail-over mode

There is a possibility to change ports to primary or secondary if you select fail-over mode on the up-link ports. I can understand that you have 1 primary and others secondary. But what is the use of assigning multiple PRIMARY ports? What happens if I assign all ports as primary ports?