- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: stacking flex10 - flex10/10D
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-19-2012 02:44 AM
11-19-2012 02:44 AM
stacking flex10 - flex10/10D
Hello,
I want to stack Flex10 Module with flex10/10D Module (VC stacking).
Enc1 - Bay1/Bay2 Flex10
Bay3/Bay4 VC FC 20Port
Enc2 - Bay1/Bay2 Flex10/10D
Bay3/Bay4 VC FC 20Port
Is this supportet? Or do I need in Bay1/Bay2 the same Module´s?
thx
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2012 08:34 AM
11-22-2012 08:34 AM
Re: stacking flex10 - flex10/10D
I found the the solution in the Bladesystem Setup and Install Guide:
All enclosures must have the same HP VC Flex-10/10D module configuration. For example, if bays 1
and 2 of the Primary Enclosure contain HP VC Flex-10/10D modules, then bays 1 and 2 of Remote
Enclosures 1, 2, and 3 must also contain HP VC Flex-10/10D modules.
So for my understanding, you cannot do multi-enclosure stacking with different Modules in Bay1/Bay2.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-29-2012 11:02 PM
11-29-2012 11:02 PM
Re: stacking flex10 - flex10/10D
I checked with someone very close to the VC Engineering team and he said that warning may have been added prematurelty as it pertains to a future feature.
For traditional Ethernet you can mix different Flex10 and 10D models in the same MES.
If you have an HP Contact (Sales person or PreSales SA) and an NDA in place, ask for a VC Roadmap and I am sure the future feature I am referring to will be obvious. But even then you might not use it right away.