BladeSystem - General
1748209 Members
2732 Online
108759 Solutions
New Discussion

Re: the virtual connection flex-10 interconnection configuration change

 
singvey
Frequent Advisor

the virtual connection flex-10 interconnection configuration change

we have two hp c7k blade systems.  when we removed the vc flex-10 interconnect modules from the c7k chassis, we forgot to mark which c7k chassis  they were removed from.  what will happen if we install the vc flex-10 interconnect modules into the wrong c7k chassis?

 

1-each chassis will maintain its original vc configuration

2- the configuration of the vc on the chassis will be swapped

3- both chassis will default to factory default settings.

4-POST will issue a warning that the wrong vc modules are inserted .

 

 

P.S. This thread has been moved from HP BladeSystem > Virtualization to HP BladeSystem Virtual Connect. - Hp Forum Moderator

2 REPLIES 2
Psychonaut
Respected Contributor

Re: the virtual connection flex-10 interconnection configuration change

Assuming that the domain is only these two VC's (and that the chassis are not stacked); #2 is what should happen.  

 

 

Server-Support
Super Advisor

Re: the virtual connection flex-10 interconnection configuration change

So how did you finally end up with the solution or the situation ?

 

please share it here :-)

Best regards,