HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem Virtual Connect
cancel
Showing results for 
Search instead for 
Did you mean: 

view the FC uplink port used by blades

 
bradshr
Frequent Contributor

view the FC uplink port used by blades

Within VC FC , is there a way of showing the uplink port that is being used by a blade or blades at any given time. I am interested in doing this to view the login distribution. We have HP VC 8Gb 24-Port FC Module on the latest firmware.

2 REPLIES
Hongjun Ma
Trusted Contributor

Re: view the FC uplink port used by blades

if you check SAN fabric tab on the left panel

 

 

you should see something like this

 

My VC blog: http://hongjunma.wordpress.com



bradshr
Frequent Contributor

Re: view the FC uplink port used by blades

hi, each of our SAN fabrics has two uplink ports. I cannot see from the diagram below which uplink port is being used, although it does display fabric, HBA port and profile.

 

how would the uplink port in use be displayed?