- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- First Hyper-v setup advice
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2012 04:59 AM
02-15-2012 04:59 AM
First Hyper-v setup advice
I'm going to build my first Hyper-v and I need some advice.
I have a C7000 with Ethernet pass-thru, 2 BL460 G7 and a D2200sb.
If I understand it right I need 2 x VSA Left hand on each BL460 to talk to the D2200sb, right?
Is it a bad idea to use the Ethernet pass-thru instead of Virtual Connect? Virtual Connect are so expansive.
Will my ISCSI traffic take one of the NICs on each BL460 and then go down to the switch and back to the D2200sb?
Any other advice?
/Christian
- Tags:
- Hyper-V
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2012 08:12 AM
02-15-2012 08:12 AM
Re: First Hyper-v setup advice
Please refer to the following documents for more information in setting up P4000 VSA:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02512877/c02512877.pdf
More documents are available at:
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01729139/c01729139.pdf
You may use Ethernet pass-through modules to connect the D2200sb. Virtual Connects may also be used.
Regards,
Vijayasarathy
Views expressed herein are my personal opinion and are not the views of HPE