Client Automation Standard Practitioners Forum
Showing results for 
Search instead for 
Do you mean 

Hiding Radtray icon with reboot panel display

Trusted Contributor

Hiding Radtray icon with reboot panel display

Hi everyone,

I have the following requirement :
(a) Hide Radtray
(b) Display the reboot panel if any application requires reboot on installation , repair, etc . This panel should have the timeout value displayed.

I tried a few options and here are my observations :

1. In CSDB editor set RADTRAY=N in BASE_INSTANCE of Setting Class under Client domain.

2. Modify the ZSERVICE.REBOOT value as "AI=SY,AR=SY".

3. At the agent side run radskman with the following parameters :
"radskman ip=xxxx,uid=xx,ask=Y,hreboot=Y,rtimeout=360 ".

If I add "ind=N" in the above command, the radtray is invisible as per the requirement. The reboot panel gets displayed but it does not show the timeout value. Offcourse if i don't take any action on the panel, the system gets rebooted after the specified timeout value ( 360 seconds) which shows that the application is respecting the timeout value.

If I don't specify the "ind=N" parameter , the radtray is visible and the reboot panel gets displayed fine with the time out value as well.

Please suggest how I can combine the 2 features ( showing reboot panel with timeout values AND hiding the Radtray).

Thanks,
Praveen
1 REPLY
Trusted Contributor

Re: Hiding Radtray icon with reboot panel display

This sounds like a CAE question vs a CAS question. I suggest moving this to the CAE forum as CSDB editor and other mentions here are not available in CAS.
//Add this to "OnDomLoad" event