HP AP 420

[Mariog1]

Hi all,

I have a new HP 420 AP that I'm trying to configure, I have accessed it using Putty and managed to set a country.

Then I enter the config command, and I type "interface wireless g" to access the wireless configuration, but it gives me an error "No interface wireless g". I'm unable to configure the wifi, I tried using the web aswell but I couldn't select an Index when creating a new SSID.

Any tips please?

[drk787]

Hi ,

Generally the radio is disabled if country code is not set, since you have already set the country code, save and reboot the deivce and check the 'show interface wireless g'. If still same issue, try factory resetting it.

To run the factory default reset on the access point, perform these steps:
1. Using a pointed object, press and hold the Reset button on the back of the
access point for 5-10 seconds. On the console display, the cursor will move
down to the next line, indicating that the factory defaults have been
reloaded.
2. Release the Reset button.
The access point will then complete its self test and begin operating with
its configuration restored to the factory default settings.
To restore the factory default configuration using the console, run the
reset configuration command from the console command prompt.