- Community Home
- >
- Networking
- >
- Legacy
- >
- Communications and Wireless
- >
- J3515A NIC for a D350
Communications and Wireless
1753449
Members
6207
Online
108794
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-05-2002 12:50 PM
12-05-2002 12:50 PM
J3515A NIC for a D350
I built a system on an HP D350 machine using an ignite from what I thought was an identical D350. Found out that the new machine was missing a 100baseT card (only had the internal 10baseT). I put an HP J3515A NIC in the machine and when the system boots up it sees the card and will configure the ip address but only sees the speed as 10HD. I edited the /etc/rc.config.d/hpgsc100conf file and changed the speed to 100FD rebooted and the lanadmin still shows it as 10HD. I used /usr/sbin/lanadmin -X 100FD 5 (which is the NMID of the card) rebooted and lanadmin still shows it as 10HD. I've just reloaded the J3515A driver and that didn't change anything.
Any other ideas of how to get this blinking thing to go to 100FD????????
ecs
Any other ideas of how to get this blinking thing to go to 100FD????????
ecs
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP