Installing hp-health on Proliant DL360 G4 with Ubuntu 10.04.2 Lucid LTS

[MattHansen]

I continue to see the following error when trying to install hp-health...

Setting up hp-health (8.5.0.1.2-2) ...
Starting Proliant System Health Monitor (hpasmd): [ FAILED ]

invoke-rc.d: initscript hp-health, action "start" failed.
dpkg: error processing hp-health (--configure):
subprocess installed post-installation script returned error exit status 127

Afterwards the server will reboot and during the boot process hpasmd loads but a few moments later has a critical error and restarts the system, which continues to loop until hpasmd is disabled.

Unsupported? Known issue? Ideas?


Thanks!


HP DL360 G4 - 6i Smart Array
Ubuntu Server 10.04 AMD 64

[MattHansen]

Discovered a few hardware issues, with the fibre channel card. It seemed to be loading and recognized by the hardware but wasn't being used so after removing it hp-health (HP Advanced System Recovery Daemon) stopped rebooting the server constantly. Is this a known issue with the QLogic cards and hp-health?


07:01.0 Fibre Channel: QLogic Corp. ISP2312-based 2Gb Fibre Channel to PCI-X HBA (rev 02)
Subsystem: Compaq Computer Corporation Device 0100
Flags: 66MHz, medium devsel, IRQ 48
I/O ports at 5000 [size=256]
Memory at fdff0000 (64-bit, non-prefetchable) [size=4K]
[virtual] Expansion ROM at 80000000 [disabled] [size=128K]
Capabilities: [44] Power Management version 2
Capabilities: [4c] PCI-X non-bridge device
Capabilities: [54] Message Signalled Interrupts: Mask- 64bit+ Queue=0/3 Enable-
Capabilities: [64] CompactPCI hot-swap
Kernel modules: qla2xxx