- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: 4500 trunking mode not working.. help
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2010 05:33 AM
01-18-2010 05:33 AM
4500 trunking mode not working.. help
Hey,
I'm newbie to 3com switch and are setting up a simple network in our office.Basically I need 2 vlan to be able to talk to each other on all the 26 ports & I set the trunking mode on the all the 26 ports.It means at anytime I need to connect to any of the 26 ports , as long as my client devices are configured correctly with the IP range below and gateway I should able to ping or talk to to each other. But I have no luck doing that work.
vlan 1 192.168.1.0/24 , vlan IP 192.168.1.1/24
vlan 2 192.168.2.0/24 vlan ip 192.168.2.1/24
Im using the latest 3com software on the switch.
Any advise or command are highly appreciated.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-26-2010 02:56 PM
01-26-2010 02:56 PM
Re: 4500 trunking mode not working.. help
Hi, can you show config of the switch?
I'm not shure because i dont know specially 4500 but if there is command like port trunk permit vlan relative to a single interface, with this command you can set a range of vlan's can pass with this specific port, remember, when you connect an endpoint station on some trunk port, you must set in which vlan the endpoint have to be.
Good luck