Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

5500G configure multiple ports at once

SOLVED
Go to solution
Highlighted
chris2016
Occasional Contributor

5500G configure multiple ports at once

All,

 

is it possible to configure ACLs for multiple ports at once on 3 Com 5500G?

I couldn't find a range or to parameter.

I want to add an ACL to all ports but one.

Thank you in advance!

2 REPLIES
network_king
HPE Pro
Solution

Re: 5500G configure multiple ports at once

Creating ACL's on multiple ports is possible.

 

Environment : 5500 Switch Version: Version 5.20.99, Release 2221P18

Pre-requisite : Check if interfaces are in route mode or change interfaces as below

Interface range GigabitEthernet 1/0/X to GigabitEthernet 1/0/XX
port link-mode route

Solution: Create an ACL and call it either inbound / outbound as needed

[HP]int range GigabitEthernet 1/0/3 to GigabitEthernet 1/0/10
[HP-if-range]packet-filter 3000 inbound

 

Please refer link for more info on ACL configuration:  https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c02644504

 

I am an HPE Employee

Please consider marking it as an Accepted Solution if issue is resolved. Register a Kudo by clicking the thumb if this helped in your issue.
chris2016
Occasional Contributor

Re: 5500G configure multiple ports at once

Thank you! I will try this, when I've to change something on those switches the next time. Thank you for the PDF, I had not found it.

 

Chris