- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: 5500G configure multiple ports at once
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-23-2017 10:26 AM
11-23-2017 10:26 AM
All,
is it possible to configure ACLs for multiple ports at once on 3 Com 5500G?
I couldn't find a range or to parameter.
I want to add an ACL to all ports but one.
Thank you in advance!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-28-2018 12:06 AM
02-28-2018 12:06 AM
SolutionCreating ACL's on multiple ports is possible.
Environment : 5500 Switch Version: Version 5.20.99, Release 2221P18
Pre-requisite : Check if interfaces are in route mode or change interfaces as below
Interface range GigabitEthernet 1/0/X to GigabitEthernet 1/0/XX
port link-mode route
Solution: Create an ACL and call it either inbound / outbound as needed
[HP]int range GigabitEthernet 1/0/3 to GigabitEthernet 1/0/10
[HP-if-range]packet-filter 3000 inbound
Please refer link for more info on ACL configuration: https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c02644504
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-02-2018 11:33 AM
03-02-2018 11:33 AM
Re: 5500G configure multiple ports at once
Thank you! I will try this, when I've to change something on those switches the next time. Thank you for the PDF, I had not found it.
Chris