5920AF ipv6 PBR wont apply, claims not enough resources

[marvias]

Hello,

I need to implement PBR for ipv6 on HPE 5920AF switch and when I attempt to apply it to interface, I get error

[switch-Vlan-interface2]ipv6 policy-based-route PBR-ipv6
Not enough resources to complete the operation, slot 1.

but checking reqources, there should be enough of them

<switch>display qos-acl resource
Interfaces: XGE1/0/1 to XGE1/0/24
---------------------------------------------------------------------
 Type             Total      Reserved   Configured Remaining  Usage
---------------------------------------------------------------------
 VFP ACL          1024       256        0          768        25%
 IFP ACL          2048       1024       749        275        86%
 IFP Meter        1024       512        0          512        50%
 IFP Counter      1024       512        0          512        50%
 EFP ACL          1024       0          0          1024       0%
 EFP Meter        512        0          0          512        0%
 EFP Counter      512        0          0          512        0%

Here is some more info from the switch

<switch>dis acl ipv6 all
Advanced IPv6 ACL  3020, named -none-, 1 rule,
ipv6 PBR bypass
ACL's step is 10
 rule 10 permit ipv6 destination 2A00:0C00::/29

Advanced IPv6 ACL  3021, named -none-, 1 rule,
ipv6 PBR
ACL's step is 10
 rule 10 permit ipv6 source 2A00:0C04::/36

<switch>dis ipv6 policy-based-route
Policy name: PBR-ipv6
  node 10 deny:
    if-match acl 3020
  node 20 permit:
    if-match acl 3021
    apply next-hop 2A00:0C00:1::1

<l3sw-mwifi-5920>dis cur int vlan2
interface Vlan-interface2
 ip address xxx
 ip address xxx sub
 ip policy-based-route xxx
 ipv6 address FE80::1 link-local
 ipv6 address 2A00:0C00:1:2::1/64

<switch>dis version
HPE Comware Software, Version 7.1.045, Release 2432P05
Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
HPE 5920AF-24XG Switch uptime is 8 weeks, 1 day, 4 hours, 18 minutes
Last reboot reason : Cold reboot

Wondering if there is maybe something I am doing wrong, or I need to allocate manually resources to ipv6 rules? I know there is one patch newer firmware, but I checked release notes and dont see any mentioning of ipv6 PBR.

[marvias · Accepted solution]

answering my own question, freeing additional resources resolved the issue. After cleanup I got to around 50 configured rules for ipv4 and application of ipv6 PBR passed.