ALLOW VLAN VOICE IN PORTS, SWITCH A3600???

[ELVINCONCE]

hi people.

iam new in configuration switches hp. so, i had configurated the switch as trunk on port gigabitethernet 25.

the scenary is the next: on my network i have vlan created as vlan 200 to voice and vlan 60 to data in others swiitches cisco.

I need to configure all ports that allow vlan voice on switch HP.

on cisco the configuration of one port is the next:

example: 

interface FastEthernet1/0/1

switchport access vlan 60

switchport mode access

switchport voice vlan 200

spanning-tree portfast !

I need to know the equal commands to use it on sw HP.

thanks!

P.S. This thread has been moved from witches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. - Hp Forum moderator

[Vince-Whirlwind]

Cisco "ACCESS" = HP "UNTAGGED"

Cisco "VOICE" = HP "TAGGED".

By default, the port will come up in 3 seconds. 

To make the ports come up quickly, you should enable:

spanning-tree admin-edge-port

But to protect the port, you should also add:

spanning-tree bpdu-protection