HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Baseline 3C16476BS resets after reboot

 
mookm420
Occasional Visitor

Baseline 3C16476BS resets after reboot

Hi



We have two Baseline 3C16476BS switches, one Baseline 3C16476CS and one 4200G 3CR17661-91.



Due an abrupt APC UPS reboot (probably), 3C16476BS switches now VLAN resets the configuration after every reboot.



3C16476CS and 4200G switches are fine.



If you just create VLANs, the reset does not happen but as soon as you assign ports to VLANs, the configuration is reset after reboot.



I reset the switch to factory settings but this did not help.

Upgrading the firmware to V1_0_1_0 also did not help.



I found a similar problem at http://tinyurl.com/n7jjvf where trunk information is lost after reboot. The suggestion is to apply path ES3250A-32_V1_0_1_1.bix.



This patch is not listed on the switch support site http://www.3com.com/swd/jsp/user/result.jsp?selected=all&sort=effdt&order=desc&sku=3C16476BS



Could someone please help me where do I find this patch ES3250A-32_V1_0_1_1.bix?



PS: We have purchased these switches as refurbished switches so do not have any support service.

This message was edited by mookm420 on 6-13-09 @ 1:00 PM
1 REPLY
mookm420
Occasional Visitor

Re: Baseline 3C16476BS resets after reboot

Is there any solution?

please help



thanks