- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Baseline Switch 2924-SFP Plus unable to configure ...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-10-2012 10:39 PM - last edited on 03-10-2013 10:23 PM by Maiko-I
09-10-2012 10:39 PM - last edited on 03-10-2013 10:23 PM by Maiko-I
Baseline Switch 2924-SFP Plus unable to configure ACL after setting up QoS
Hi there!
My Problem is about the Baseline Switch 2924-SFP Plus Switch.
When I configure a QoS rule on a port, it is no more possible to bind a ACL rule onto the same port, that's totally normal.
But, if I delete the QoS rule, it should be possible to bind a ACL to the port. But it isn't.
I need ACLs for my clients, so if I once configured a QoS rule on a port, I can never use this port again for my clients, that brings me to despair.
I hoped that the newest firmware would fix it, so I loaded the newest firmware file onto the switch and the problem is still the same.
Is anybody out there who can help me??
P.S. this thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based - Hp Forums Moderator