HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Basic config of A5500

 
Tim Gowen
Occasional Contributor

Basic config of A5500

I'm replacing a pair of 24 port Superstack switches with a 48 port A5500. The Superstacks don't have any special configuration enabled: they're just plug and play switches. I'd like the 5500 to be the same until I've replaced all old Superstacks on the network with new HP switches.

 

There's a fibre module in the new switch with a transceiver which will connect the switch back to a 3Com 4800G which is my core fibre switch for this building.

 

For this basic configuration it looks like all I need to do is assign the switch an IP address. Is there a default VLAN which is created or will I have to do that too?

1 REPLY
paulgear
Esteemed Contributor

Re: Basic config of A5500

Check out the configuration guides available from HP's web site. They step you through the basics pretty well. Tip: use Google to search for them, not HP's web search.
Regards,
Paul