- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Blank Console screen
Comware Based
1753777
Members
7599
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-02-2009 09:20 AM
10-02-2009 09:20 AM
Blank Console screen
Hello folks -
I am trying to console into two 3COM 4400 SE 24 port switches, however keep getting a blank screen on both of them. I have tried different cables, but still get the same result.
I have used all possible settings for baud rate, but that didn't help either. Even tried different machines to console from, but that too did not help. So not sure what the problem is.
Can anyone suggest what else I can try?
Thanks for your help.
I am trying to console into two 3COM 4400 SE 24 port switches, however keep getting a blank screen on both of them. I have tried different cables, but still get the same result.
I have used all possible settings for baud rate, but that didn't help either. Even tried different machines to console from, but that too did not help. So not sure what the problem is.
Can anyone suggest what else I can try?
Thanks for your help.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-02-2009 03:59 PM
10-02-2009 03:59 PM
Re: Blank Console screen
Do you have access to the switches using some network management software? Try to check the access settings.
I think you cannot perform a reboot on these switches, but if they don't show you nothing on the console nor even on the NMS, a reboot will be a good try to solve or at least isolate the problem.
regards
I think you cannot perform a reboot on these switches, but if they don't show you nothing on the console nor even on the NMS, a reboot will be a good try to solve or at least isolate the problem.
regards
Regards,
Fred Mancen
Fred Mancen
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP