CBQos HPE Device

[Colasanti1978]

Hi,

We're trying to monitor by snmp the oid 1.3.6.1.4.1.25506.2.65.2.1.5.6.2.1.4 – hh3cCBQoSClassFwdPktbps (MIB hh3c-cbqos2.mib) on HPE 5510.

On internet we found that this MIB could be not supported on HP device(Comware V7 MSR MIB Companion).

 We replied the test on other devices (3Com/HP 4800 e HP 5500) but we check the same behavior.

Our goal is monitoring every single DSCP marked throughput, in other words the “offered rate” of a Cisco Policy as follows:

 Class-map: DOMESTIC_OUT (match-any) (7552545/2)       8170810 packets, 979471829 bytes       5 minute offered rate 27000 bps, drop rate 0 bps       Match: any  (5213858)       police:         1024000000 bps, 16777215 limit, 16777215 extended limit         conformed 8170810 packets, 979471829 bytes; actions:           transmit         exceeded 0 packets, 0 bytes; actions:           drop         conformed 27000 bps, exceed 0 bps

The same command on HPE 5510 seems to be not exist (command that shows the bit rate - bps of a policy map)

Below the output of my configuration:

traffic classifier VOIP operator and

if-match acl 3000

#

traffic behavior VOIP

accounting packet

remark dscp 26

#

qos policy VOIP

classifier VOIP behavior VOIP

#

acl number 3000

rule 0 permit ip source 10.44.0.0 0.0.255.255 destination 10.44.0.0 0.0.255.255

#

interface GigabitEthernet1/0/24

qos apply policy VOIP inbound

 qos apply policy VOIP outbound

#

ANY SOLUTIONS ON HPE DEVICES?

Thanks

[maguanglongMike]

Hello

what is your netowrking topology and detailed config?