- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: Cable diagnostics or TDR testing on comware 7
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-20-2018 04:16 AM
тАО07-20-2018 04:16 AM
Hi all,
I was looking to do a cable-dianostic on an interface on a 5130-24.
I can't seem to find anything that indicates that this is possible.
Like the Cisco or Aruba (Procurve) series switches, which have some kind of measurement of cobber cables.
Like : Aruba
test cable-diagnostics 1/2
or Cisco
test cable-diagnostics tdr interface gigabitethernet1/2
after the test is run, one can typically se the result with "show cable-diagnostics ..." something
Is there a similar feature for the 5130 series?
Regards
Region Midtjylland
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-21-2018 02:49 PM
тАО07-21-2018 02:49 PM
SolutionHi @sdide, have you tried virtual-cable-test CLI command at interface view's level?
The virtual-cable-test feature tests the cable connection of an (copper [*]) Ethernet interface and displays cable test result within 5 seconds: test result includes the cable's status and some physical parameters; if any fault is detected, the test result shows the length from the local port to the faulty point.
Reference: HPE FlexNetwork 5130 EI Switch Series Layer 2 - LAN Switching Configuration Guide for Release 32xx.
[*] note that SFP/SFP+ ports aren't supported.
I'm not an HPE Employee
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО07-23-2018 12:35 AM
тАО07-23-2018 12:35 AM
Re: Cable diagnostics or TDR testing on comware 7
Hi Parnassus,
Spot on! I'm not sure how I missed that. I think I was having the idea it had to start with cable. Oh well.
Thanks!
Regards
Region Midtjylland