Comware "logging synchronous" equivalent

[Pete W]

Is there a Comware equivelant to the Cisco "logging synchronous" command?

Pete

[paulgear · Accepted solution]

Hi Pete,

http://h17007.www1.hp.com/docs/interoperability/Cisco/HP-Networking-and-Cisco-CLI-Reference-Guide_June_10_WW_Eng_ltr.pdf implies that "info-center synchronous" is available; i've not used it but i assume it does the same thing...

[Pete W]

You're absolutely right. I'm kicking myself as I had already tried that, however I just tested it again and it only redraws the line if there are characters entered after the prompt.

# Here it redraws the line because I have "interface GigabitEthernet 1/0/5" entered at the CLI

[CAB-A-5800-101]interface GigabitEthernet 1/0/5
%Apr 26 14:16:33:738 2000 CAB-A-5800-101 OPTMOD/4/MODULE_OUT:
Ten-GigabitEthernet1/0/27: The transceiver is absent.

[CAB-A-5800-101]interface GigabitEthernet 1/0/5
%Apr 26 14:16:37:867 2000 CAB-A-5800-101 IFNET/3/LINK_UPDOWN: Ten-GigabitEthernet2/0/25 link status is DOWN.
[CAB-A-5800-101]interface GigabitEthernet 1/0/5

# Here is the same error occuring, however the CLI is empty

[CAB-A-5800-101]
%Apr 26 14:18:28:738 2000 CAB-A-5800-101 OPTMOD/4/MODULE_OUT:
Ten-GigabitEthernet1/0/27: The transceiver is absent.

%Apr 26 14:18:32:298 2000 CAB-A-5800-101 IFNET/3/LINK_UPDOWN: Ten-GigabitEthernet1/0/27 link status is DOWN.
%Apr 26 14:18:32:443 2000 CAB-A-5800-101 STM/3/STM_LINK_STATUS_DOWN:
IRF port 2 is down.
%Apr 26 14:18:32:553 2000 CAB-A-5800-101 IFNET/3/LINK_UPDOWN: Ten-GigabitEthernet2/0/25 link status is DOWN.
%Apr 26 14:18:32:683 2000 CAB-A-5800-101 STM/3/STM_LINK_STATUS_DOWN: -Slot=2;
IRF port 1 is down.

Regards,

Pete W

[paulgear]

It's a bit of a shame that it's buggy, but at least you know that if you don't see the prompt, it's safe to press enter...

If you find the right channel through which to report it (i've never tried this, so i'm not sure how easy or hard it is), maybe you can get them to fix it in a future firmware revision.

[reneoliveirajr]

Hello all,

Can't be a bug for all this time... I'm trying to configure a H3C S5300 with last firmware...

But I still cannot disable the intruder logs in aux0, when I try to use the command: info-center synchronous

WHat we can do?

Best Regards!

[Apachez-]

You can disable logging to the "screen" if you wish?