HPE Community
Comware Based
1753415 Members
6951 Online
108793 Solutions
New Discussion

Connecting 3COM Baseline 2928-SFP Plus Switches

 
mortonic
Occasional Contributor

‎11-17-2009 04:19 AM

‎11-17-2009 04:19 AM

Connecting 3COM Baseline 2928-SFP Plus Switches

I am currently using four 3COM Baseline 2928-SFP Plus Switches for our company network. However, they are only connected to each other via a single cable plugged into a 1gb port on each switch.



There must be a faster, better way to do this. Does anyone have any suggestions?



Please bear in mind that I'm fairly new to networking!

0 Kudos
1 REPLY 1
Fred_Mancen_1
Super Advisor

‎11-17-2009 09:06 AM

‎11-17-2009 09:06 AM

Re: Connecting 3COM Baseline 2928-SFP Plus Switches

You can enable the LACP protocol on the uplink ports and use two uplinks per switch, creating automatic link aggregation groups. This feature increases the throughput (2 x 1Gbps) and provides redundancy.



HTH.

Regards,
Fred Mancen
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.