- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Disable bpdu-protection re-enable using 'shutdown-...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-31-2015 05:12 AM
07-31-2015 05:12 AM
Disable bpdu-protection re-enable using 'shutdown-interval'
All,
In COMWARE 5 in order to stop the port from trying to come back up every 30 seconds after 'bpdu-protection' took down a port you were able to issue the global command 'shutdown-interval 0'. 0 is no longer and option in COMWARE 7 so is there another way to disable the timer from tryign to bring the port up so it stays down until its manually enable?
Appreciate the assistance.
Phil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2015 08:24 PM
08-02-2015 08:24 PM
Re: Disable bpdu-protection re-enable using 'shutdown-interval'
The Layer2 Configuration Guide says,
"For more information about this detection interval, see Fundamentals Configuration Guide."
The Fundamentals Configuration Guide has nothing in it about STP, let alone about BPDUs and the detection interval.
Dead end.
Why can't they describe the BPDU detection interval within the STP chapter of the Layer2 config guide, where it belongs?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-09-2015 08:55 AM
10-09-2015 08:55 AM
Re: Disable bpdu-protection re-enable using 'shutdown-interval'
Upgrading to latest firmware should give you the option.