Dot1x and phone connectivity

[RAMAKIRAN]

Hi..

I have one more query.... we are using avaya Phones ,connection is Switch port to Phone to user,as a hybrid port.and using dot1x authentication.authentication procesess is happening well.but once user disconnect from phone ,user MAC is not releasing that particular port.due to this invalid user also authenticating with same port.

For this need "Port-security mac move permit".this command is not available in comware 5.2 version.My all switches are running in 5.2version.So please help me how to do MAv-move in comware 5.2 ver...

[Nitish_N]

Hi Ramakiran,

Please try command below command globally and check if it resolves the issue.

mac-address mac-roaming enable 

mac-address mac-move fast-update

-N

[RAMAKIRAN]

Hi....Nithish ,i am very thankful to you for helping me...

above two commands are not available in comware 5.20v in globally and interface level.Please check if any commands are there for "MAC-MOVE"

[Nitish_N]

Hi Ramakiran,

Please find the below output from HPE 5120 switch which is running comware 5.2 firmware version. Try the  two command mentioned in the bottom.

<SW1>dis version
HPE Comware Platform Software
Comware Software, Version 5.20.99, Release 2222P01
Copyright (c) 2010-2016 Hewlett Packard Enterprise Development LP
HP A5120-48G EI Switch with 2 Interface Slots uptime is 9 weeks, 4 days, 8 hours , 33 minutes

HP A5120-48G EI Switch with 2 Interface Slots with 1 Processor
128M bytes SDRAM
16384K bytes Flash Memory

Hardware Version is REV.B
CPLD Version is 007
Bootrom Version is 610
[SubSlot 0] 48GE+4SFP Hardware Version is REV.B
[SubSlot 1] 2 SFP+ Hardware Version is REV.A

[SW1]
[SW1]mac-address ?
blackhole Blackhole entry, without aging, can be added/deleted, saved
to the configuration file
destination-hit Hit destination MAC addresses
dynamic Dynamic entry, with aging, can be added/deleted, lost after
reset
information Configure MAC information function
mac-learning Hardware MAC address learning
mac-roaming Configure mac roaming
multicast Multicast entry, without aging, can be added/deleted, saved
to the configuration file
static Static entry, without aging, can be added/deleted, saved to
the configuration file
station-move station-move
timer Configure timer

[SW1]
[SW1]mac-address mac-roaming enable

[SW1]mac-address station-move quick-notify enable

-N

[RAMAKIRAN]

Hi..Thanks 

Same has been executed in global level,but still MAC is not releasing from switchport...Port is hybrid becuase we are using avaya phones in same port.