Equivalent config from C to HP

[jrj89]

I have a existing Cisco 3750 and in the process of replacing it with a A3600 El. Is there an equivalent config to enable a routed link on one of the interface of the HP switch. Or is my only option assigning the interface as a menber of vlan 2 then creating a VLAN 2 L3 interface.

interface FastEthernet1/0/48
description L3 interconnectivity to WAN, Fa0/0
no switchport
ip address 10.10.10.2 255.255.255.252
speed 100
duplex full

[Fredrik Lönnman]

I think you have to go the vlan route on the 3600. The routed port mode just got to the A5500 quite recently (comware5) and I dont think its available in the A3600. The config in A5500 are port link-mode route whereas the default is port link-mode bridge.

[MichaelM55]

This might help you: http://h17007.www1.hp.com/docs/training/HP-Networking-and-Cisco-CLI-Reference-Guide_June_10_WW_Eng_ltr.pdf