Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

FF 5700 IRF issue (cancelling bind)

danijuntak
Occasional Collector

FF 5700 IRF issue (cancelling bind)

Hi Guys,

 

I have 2 FF 5700 switches for IRF and use below Command Line.

 

system-view
irf member 1 priority 32

interface ten-gigabitethernet 1/0/39
shutdown
quit

irf-port 1/1
port group interface ten-gigabitethernet 1/0/39
quit

interface ten-gigabitethernet 1/0/39
undo shutdown

 

When i try to undo shutdown, it prompts:

 

Bind all interfaces in the same group to one or two IRF ports or cancel the bindings on all of them.

 


This is a new switch and i have reset current-configuration.

 

 

Any idea what went wrong?

Thx

--
Dani Royman Simanjuntak
Network Administrator

What You See Is What You Get
1 REPLY
Sascha_G
Occasional Visitor

Re: FF 5700 IRF issue (cancelling bind)

Hi Dani,

on the 5700 there are four physical Interfaces connected to one ASIC, all four ports in one group have to be either IRF ports or all normal ethernet ports (e.g. ports 37-40)

Here is the relevant excerpt from the 5700 IRF config guide:

When you use 10-GE ports for IRF connection, follow these restrictions and guidelines:
• The 10-GE ports are grouped by port number in order, starting from 1. Each group contains four ports. If you use one port in a group for IRF connection, you must also use all the other ports in the group for IRF connection. However, you can bind the ports to different IRF ports.