HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 5700 Receiving error creating new Snmpv3 user account

 
n3tm1n
Valued Contributor

HP 5700 Receiving error creating new Snmpv3 user account

Comware Software Version 7.1.045, Release 2311P05

Trying to create a new snmpv3 user account and recived the following error. I've changed user name/passwords for the sake of this topic.

This is the error message that IMC 7.1 provides.

system-view
System View: return to User View with Ctrl+Z.
[DEV-10GBe1]snmp-agent sys-info version v3
[DEV-10GBe1]snmp-agent mib-view included ViewDefault iso
[DEV-10GBe1]snmp-agent mib-view included ViewDefault iso
[DEV-10GBe1]snmp-agent group v3 SNMPv3Group authentication read-view ViewDefault write-view ViewDefault
[DEV-10GBe1]snmp-agent usm-user v3 v3guy SNMPv3Group authentication-mod sha AuthPass privacy-mode aes128 PrivPass
                  ^
 % Too many parameters found at '^' position.

I currently have an existing snmpv3 user configured, but I need to delete the exiting account  after creating and verifying new account is successful. Any help with how to remove existing snmpv3 account would be much appreciated.

 

 

2 REPLIES
n3tm1n
Valued Contributor

Re: HP 5700 Receiving error creating new Snmpv3 user account

Also, is there any type of character limitations for the passwords i.e. !@#$%^&*/ ?

Could not find anything in the configuration manual regarding such limitation.

pombeii
Frequent Advisor

Re: HP 5700 Receiving error creating new Snmpv3 user account

Hi, your should enter the 'cipher' or 'simple' keyword before entering authention-mode. As for your example, simple should be used.

To delete a user, use the undo form of the command. See Network management and monitoring command reference for the switch.

hope this information helps.  

Pombeii