Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 5800 Switch GUI Access

SOLVED
Go to solution
Tech_User
Occasional Contributor

HP 5800 Switch GUI Access

I havent worked on the HP switches for a long time, I'm trying to configure two new 5800 switches, i have assigned the IP and i can ping it, however i can't access the GUI.

[HP]display ip interface
Vlan-interface1 current state :UP
Line protocol current state :UP
Internet Address is 10.2.2.240/24 Primary
Broadcast address : 10.2.2.255
The Maximum Transmit Unit : 1500 bytes
input packets : 1118, bytes : 66240, multicasts : 14
output packets : 1104, bytes : 65280, multicasts : 0
ARP packet input number:          42
  Request packet:                 41
  Reply packet:                    1
  Unknown packet:                  0
TTL invalid packet number:         0
ICMP packet input number:       1057
  Echo reply:                      0
  Unreachable:                     0
  Source quench:                   0
  Routing redirect:                0
  Echo request:                 1057
  Router advert:                   0
  Router solicit:                  0
  Time exceed:                     0
  IP header bad:                   0
  Timestamp request:               0
  Timestamp reply:                 0
  Information request:             0
  Information reply:               0
  Netmask request:                 0
  Netmask reply:                   0
  Unknown type:                    0

 

5 REPLIES
parnassus
Honored Contributor

Re: HP 5800 Switch GUI Access

Probably because the HTTP (or HTTPS) service should be enabled to provide you the Web Based GUI access on default port 80 (or 443 for HTTPS).

Don't system-view and ip http enable commands work?

I mean something like:

<A5800> system-view
[A5800] ip http enable
[A5800] display ip http

Eventually check the HPE 5820X & 5800 Switch Series Fundamentals Configuration Guide here.

Here below just a screenshot of the HTTP Login configuration section (note that you require to define a local user with credentials):

HPE_5800_HTTP_login_configuration.png

 

 

Tech_User
Occasional Contributor

Re: HP 5800 Switch GUI Access

Thanks, realised that's the case.

Need to know how to delete some of the configuration, in system-view there is a delete command but it won't let me delete what i want.

Earlier i added;  'ip host name1 10.2.2.253'

How can i delete the this?

parnassus
Honored Contributor
Solution

Re: HP 5800 Switch GUI Access

Probably with a good undo (undo command):

undo ip host name1 10.2.2.253

That HPE FlexNetwork 5820X & 5800 Switch Series Fundamental Configuration Guide could be really your friend!

 

Tech_User
Occasional Contributor

Re: HP 5800 Switch GUI Access

That's done the trick, thanks for your help.

I'll definately consider making HPE FlexNetwork 5820X & 5800 Switch Series Fundamental Configuration Guide  my friend :)

parnassus
Honored Contributor

Re: HP 5800 Switch GUI Access

That's great! Good luck with your 5800!