Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 5900AF > Link-Aggregation - VMWare 5.5.0

mferna
Occasional Contributor

HP 5900AF > Link-Aggregation - VMWare 5.5.0

Hi Guys,

I have a new HP 5900AF-48XGT-4QSFP+.

Have 2 HPDL380p both with 2x10Gb ports. We need to create link-aggregation on the Switch.

Here are my Simulation config:

interface Bridge-Aggregation1  
  description TRUNK.ESX01  
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  link-aggregation mode dynamic  
  lacp edged-port
#

interface Bridge-Aggregation2   
  description TRUNK.ESX02   
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  link-aggregation mode dynamic  
  lacp edged-port
#

interface Vlan-interface12  
  description iSCSI  
  ip address 10.138.12.254 55.255.255.0  

interface Vlan-interface13   
  description vMOTION
  ip address 10.138.13.254 55.255.255.0  
#
interface Vlan-interface2   
  description AD-SERVERS
  ip address 10.138.2.254 255.255.255.0  
#  

interface Ten-GigabitEthernet1/0/1  
  port link-mode bridge  
  description ESX01.TEAM  
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  port link-aggregation group 1  
#  
interface Ten-GigabitEthernet1/0/2  
  port link-mode bridge  
  description ESX01.TEAM  
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  port link-aggregation group 1  
#

interface Ten-GigabitEthernet1/0/3   
  port link-mode bridge  
  description ESX02.TEAM  
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  port link-aggregation group 2   
#  
interface Ten-GigabitEthernet1/0/4   
  port link-mode bridge  
  description ESX02.TEAM  
  port link-type trunk  
  undo port trunk permit vlan 1  
  port trunk permit vlan 12 to 13 102  
  port link-aggregation group 2
#

On the VMWare i have the following configuration: Route based on IP hash.
VMWare Version: VMware vSphere 5 Enterprise Plus ( 5.5.0 - 1623387 )

Are this correct, is this the best way to do it? I try do put connection up with out success.

Sincereyly,
MF

3 REPLIES
Sietze Reitsma
Respected Contributor

Re: HP 5900AF > Link-Aggregation - VMWare 5.5.0

Are you using the distributed vSwitch?

Below video shows how to configure it for VMware.

http://blogs.vmware.com/techpubs/2013/10/configuring-lacp-support-in-vsphere-5-5.html

 

mferna
Occasional Contributor

Re: HP 5900AF > Link-Aggregation - VMWare 5.5.0

Hi,

But on our 5900+ the configuration is correct?

Sincerely,
MF

johnk3r
Respected Contributor

Re: HP 5900AF > Link-Aggregation - VMWare 5.5.0

Setting this right.
But always make changes directly in Bridge-Aggregation and never in the interface.

**************************************
ATP FLEXNETWORK V3 | ACSA