- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- HP 5930-32QSFP+ 40Gb to 10Gb breakout cables
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2015 09:16 PM - last edited on 01-25-2015 06:59 PM by Maiko-I
01-24-2015 09:16 PM - last edited on 01-25-2015 06:59 PM by Maiko-I
HP 5930-32QSFP+ 40Gb to 10Gb breakout cables
If we are utilizing the 40Gb to 10 Gb breakout cables on a HP5930 switch, is it possible to configure 2 separate port channels ((2 x 10 Gb) x 2) utilizing the 4 x 10 Gb cables?
Thank you.
P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. - Hp Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-26-2015 12:49 AM - edited 01-26-2015 12:50 AM
01-26-2015 12:49 AM - edited 01-26-2015 12:50 AM
Re: HP 5930-32QSFP+ 40Gb to 10Gb breakout cables
Hi,
when you issue then command
using tengige
on your fortygig interface, you get 4 independant interfaces.
I assume you can make port channels from these as usual between two Ten-gig interfaces.
Example I have a HP 5900
If i do:
interface range forty1/0/49 forty1/0/50
using tengige
quit
and reboot (required),
I get 8 ten gig interfaces: ten1/0/49:1, ..., ten1/0/49:4, and ten1/0/50:, ..., ten1/0/50:4
the BAGGs:
interface bridge-aggregation 1
quit
interface bridge-aggregation 2
quit
interface range te1/0/49:1 te1/0/50:1
port link-aggregation group 1
quit
interface range te1/0/49:2 te1/0/50:2
port link-aggregation group 2
quit
Should work.
Regards
Region Midtjylland