HP 5930-32QSFP+ 40Gb to 10Gb breakout cables

[techburgher]

If we are utilizing the 40Gb to 10 Gb breakout cables on a HP5930 switch, is it possible to configure 2 separate port channels ((2 x 10 Gb) x 2) utilizing the 4 x 10 Gb cables?

Thank you.

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to Comware-Based. - Hp Forum Moderator

[sdide]

Hi,

when you issue then command

 using tengige

on your fortygig interface, you get 4 independant interfaces.

 I assume you can make port channels from these as usual between two Ten-gig interfaces.

Example I have a HP 5900

If i do:

interface range forty1/0/49 forty1/0/50

 using tengige

 quit

and reboot (required),

I get 8 ten gig interfaces: ten1/0/49:1, ..., ten1/0/49:4, and ten1/0/50:, ..., ten1/0/50:4

the BAGGs:

interface bridge-aggregation 1

 quit

interface bridge-aggregation 2

 quit

interface range te1/0/49:1 te1/0/50:1

 port link-aggregation group 1

 quit

interface range te1/0/49:2 te1/0/50:2

 port link-aggregation group 2

 quit

 
Should work.

Regards