HPE Community
Comware Based
1751853 Members
5553 Online
108782 Solutions
New Discussion юеВ

HP A5500-24G SI Switch Make Port Layer3

 
tenable
Occasional Contributor

тАО12-05-2010 12:14 AM

тАО12-05-2010 12:14 AM

HP A5500-24G SI Switch Make Port Layer3

Is there any way to make A5500-24G physical port Layer3, like in cisco there is command no switchport, and layer2 port becomes layer3 ?

0 Kudos
2 REPLIES 2
Fredrik L├╢nnman
Honored Contributor

тАО12-05-2010 01:17 AM

тАО12-05-2010 01:17 AM

Re: HP A5500-24G SI Switch Make Port Layer3

No, that is only possible on the A-series routers. Youll have to use a vlan and access port.

---
CCIE Service Provider
MASE Network Infrastructure [2011]
H3CSE
CCNP R&S

0 Kudos
JRojas_chile
New Member

тАО12-20-2010 04:49 AM

тАО12-20-2010 04:49 AM

Re: HP A5500-24G SI Switch Make Port Layer3

I don┬┤t know if it┬┤s posible for a A5500 family, but in the A7500 switches the command  for do that is under interface configuration,  port link-mode (bridge - router)

 

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.