Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

HP FlexFabric 5700 OSPF not working.

 
Kashif123
Occasional Visitor

HP FlexFabric 5700 OSPF not working.

Not able to get Full/DR state...just says exchanging...AT&T Layer 2 P2P circuit.

also not able to use 'port link-mode bridge' cmd. no such cmd avaliable. both switches are runing Release 2432P06-US.

#
ospf 1 router-id 1.1.1.2
area 0.0.0.0
network 0.0.0.0 255.255.255.255

#
vlan 40
description Inter-Site Routing VLAN
protocol-vlan 0 ipv4

#
interface LoopBack0
ip address 1.1.1.2 255.255.255.255

interface Vlan-interface40
ip address unnumbered interface LoopBack0
ospf cost 2
ospf network-type p2p

#
interface Ten-GigabitEthernet1/0/23
description AT&T Ethernet Service (P2P OD) CIRCUIT
bandwidth 150000
port access vlan 40
lldp management-address arp-learning vlan 40
lldp tlv-enable basic-tlv management-address-tlv 1.1.1.2

1 REPLY
Highlighted
network_king
HPE Pro

Re: HP FlexFabric 5700 OSPF not working.

For OSPF configuration guide please refer below guide.

Page 66 onwards > https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=1008635527&docLocale=en_US&docId=emr_na-a00038289en_us

 

For bridge port use command [device]port bridge enable 

I am an HPE Employee

Please consider marking it as an Accepted Solution if issue is resolved. Register a Kudo by clicking the thumb if this helped in your issue.