- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- HPE 5800-24G-PoE+ JC099A puerto enrutado
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2021 07:41 PM
04-06-2021 07:41 PM
HPE 5800-24G-PoE+ JC099A puerto enrutado
Buenas noches,
El switch de referencia HPE 5800-24G-PoE+ JC099A soporta la caracteristica de puerto enrutado (puerto capa 3)?
Algo asi como el equivalente de los switch multicapa de cisco en donde se realiza la siguiente configuración para obtener un puerto capa 3:
interface GigabitEthernet0/0
no switchport
ip address 1.1.1.1 255.255.255.0
no shutdown
exit
Tengo la duda de si esta referencia del switch HPE soporta la configuración del comando: port link-mode route, para la configuración del puerto en capa 3.
Gracias, por la aclaración!..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2021 08:19 PM
04-06-2021 08:19 PM
Re: HPE 5800-24G-PoE+ JC099A puerto enrutado
Hello @Agomez16
Good Day!
Yes, this switch support route port feature and yes the command is same which you have mentioned.
'port link-mode route' when you are disabling bridge mode and enablying layer 3 feature.
Below command to swap back to bridge mode:
'port link-mode bridge'
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-11-2021 01:21 AM
04-11-2021 01:21 AM
Re: HPE 5800-24G-PoE+ JC099A puerto enrutado
Hello,
Has my post helped you to answer your query?
Thanks!