- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- IRF Node Replacement
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
05-18-2013 10:41 AM
05-18-2013 10:41 AM
IRF Node Replacement
Hi Friends,
I am new to HP Switches,
We have two HP5500-24G EI switches stacked using IRF..
just has quary while replacing faulty node,
we have to do IRF configuration same as we did on faulty switch and then need to add in IRF ?
is configuration related to that node will erase ?
Thanks,
Deep17
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
05-18-2013 12:19 PM
05-18-2013 12:19 PM
Re: IRF Node Replacement
I would probably boot up the new switch, install the same image as the IRF stack, configure it with the switch ID its supposed to have in the stack, power off, connect to the stack and power on. It will receive the config from the stack master after stack merge.
CCIE Service Provider
MASE Network Infrastructure [2011]
H3CSE
CCNP R&S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
05-18-2013 10:30 PM
05-18-2013 10:30 PM
Re: IRF Node Replacement
Thank you Fredrik for your valuable reply.
Regards,
Deep17
Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP