HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

Is it possible to have a mixture of DCB and non-DCB iSCSI traffic on a Flexfabric 5930 IRF stack?

 
GerryOBrien
Occasional Contributor

Is it possible to have a mixture of DCB and non-DCB iSCSI traffic on a Flexfabric 5930 IRF stack?

Hi,

  Is it possible to have a mixture of DCB and non-DCB iSCSI traffic on a Flexfabric 5930 IRF stack? We are trying to connect a variety of Dell SAN storage devices, some of which have iSCSI DCB and some don't, via a 4 x 5930 IRF stack. The Dell 'Best practices' guide says that all traffic in the Layer 2 network must either be DCB or else not. Is it possibe to partition SAN traffic into something like VSAN groupings so that DCB can be enabled on a subset of VLANs?

    Regards,

      Gerry