Comware Based
1748195 Members
2660 Online
108759 Solutions
New Discussion

Issue assigning an IP on int GE0/1 on MSR954 router

 
lennutrajektoor
Occasional Advisor

Issue assigning an IP on int GE0/1 on MSR954 router

Hello everyone!

Could someone help me out and explain why Comware 7 on MSR954 JH297A router refuses to accept IP ADDRESS command to assign an IP to GE0/1 yet every available manual assures that's the way to do it?

SY

INT G0/1

IP ADDRESS 192.168.3.1 255.255.255.0

<Unregonized command found at '´`' postion>

I can't assigne an IP just by IP SOURCE BIND IP-ADDRESS 192.168.3.1

I'm just desperate.

 

1 REPLY 1
lennutrajektoor
Occasional Advisor

Re: Issue assigning an IP on int GE0/1 on MSR954 router

Solved the issue - GE0/1 was in PORT LINK-MODE BRIDGE (LAYER2).

Must have been set to PORT LINK-MODE ROUTE (LAYER 3).

All is there just the manuals don't specify you have to be careful with PORT LINK-MODE.

Wasted 2 days on this issue. Hoped to finish config on the router over the weekend.